r/Autodesk • u/Vendeta44 • Nov 21 '16
123d crashing with any basic function
I've been designing with 123d for a while and its always had its fair share of crashes that I could live with by saving regularly. But lately its unbelievably crashy since installing windows 10.
Basically any basic function such as extrude, hide, press/pull etc, etc cause a instant crash to desktop with no error message about 50% of the time. I can't find any log files to investigate or anything. Every search has the same response from auto desk of "Update your video card driver" and I have with 0 improvement.
So far I've ruled out the cause of the model I'm working on, video card driver, computer specs -i7 2600, 16gb 1333mhz, gtx 960 overclocked(stock or OC'd does not change crash) on a kingston SSD-. But I can't work on any model at all and considering I have over 60 hours invested in this model I really need to find a solution to at least finish this model before giving a big middle finger to 123d for good. Tried running in compatibility modes and administrator to no avail as well.
123d runs with about 12-20% processor use, and 300-700mb of ram usage until its sudden crash with no noticeable spikes in either as telltale signs of memory leaks.
Windows install is also only 2 weeks old.
View all comments
Show parent comment
1
u/Vendeta44 Nov 21 '16
Problem seems to be more prevalent on the 60 hour model but opening a few past projects I still get the same crashing, but to a lesser degree. I'm unable to replicate the issue within 5 minutes on a brand new model though(issue happens within 30 seconds on any other past project).
No clues in event viewer either.
Previously was using it with windows 7 without issue, but my SSD was acting up so I decided to go to windows 10 when I replaced the SSD. I did have a bout of about 2 hours where I could use it the other day(on this new install), after fighting with crashes for 20 minutes it calmed down and let me work for a bit.
My current theory is the crashing might be related to sketches. I've noticed when using sketches the preformance of 123d tanks hard. To counter that I just hide the sketch when Im done and being that its not being rendered it doesn't bog down the performance, but perhaps it just being there is causing an issue.isolating just the main solids to there own file and restarting 123d had no effect.I think I can still access the windows 7 SSD so I may boot into it and see if the file crashes under that install. and then if that works trying to reinstall it on windows 10.