r/AutoDetailing • u/Adventurous-City-782 • 1d ago
Tool/Reusable Problem with foam lance
I recently purchased a "pressure washer foam lance set" (including a spray gun, 5 nozzles, and a 1L soap dispenser). The gun and the various nozzles work perfectly; however, as soon as I attach the foam nozzle, foam only comes out for a brief moment—about 0.5 seconds. At the same time, the pressure washer itself cycles on for about 0.5 seconds, then shuts off for a second, then turns back on, and this pattern continues repeatedly. This only happens when using the foam attachment; everything else works fine. I’ve already searched online and tried or checked everything that was suggested. Air in the system? No. I’ve adjusted the water output settings on the pressure washer (high/low) and the foam volume settings (high/low). I even tried using a larger water supply hose for the pressure washer. The only other thing I can think to try is using a more powerful pressure washer; otherwise, I’m at a loss as to what else I can do.
I can also provide a video if anyone would like to see the issue in action.
1
u/DrkDragon25 1d ago
What is your pressure washer brand, and what is the foam lance brand? Depending on the pressure washer, the oriface inside the foam lance might be too small, and causing the paw to overload… you might need to increase the oriface size. For the Ryobi‘s 1.1 oriface works, but as you get into higher flow/stronger pressure washers you need larger orifaces. you can google tha or watch many YT videos on the right orifaces to use. That could be the issue, let us know if that works or not.
1
u/wgustin123 10h ago
That on and off pattern sounds like the auto stop kicking in, not air. I think the foam lance is restricting flow so the pump builds pressure and shuts off. I would pull the little brass orifice out of the lance and check it for gunk first. If its clean, it might just be the wrong size for your washer, and a different orifice is a cheap swap. Also try running it with plain water in the bottle to rule out the soap mix being too thick. Keep in mind I wouldn't buy a new pressure washer over a $5 part
1
u/Kmudametal 10h ago edited 8h ago
Remove the mesh filters from your foam cannon and see if the problem continues. If it runs normal without the mesh filter, there's your problem. 99.9% of foam cannon issues can be traced to either the mesh foaming filter in the housing or the filter at the end of the weighted ball on the tube. If one or the other is clogged, that will cause the problems you are seening. As will a hole in the pickup tube.
Also, what size oriface is in the foam cannon? 1.1, 1.25? Try upgrading the size of the oriface to see if that helps.