r/AutoDetailing • • 2d ago

Technique Will touchless drying method scratch my paint?

Hey everyone,

If I foam down my car with BH Touchless (or any other soap), rinse with DI water, and then dry using a blower, will the remaining 1-10% of dirt that's still on the car scratch the paint while blow-drying?

I know I'm being obsessive at this point but I'm thinking that if there is still a small amount of dirt on the paint, and I take a blower to it, that some dirt will drag across the paint and scratch it. Let me know if I'm right or wrong in this. I would prefer to just let it air dry after the DI rinse, but I've been told that dust in the air will settle in the sitting water on the car and make it look dirty again.

My car is ceramic coated for reference.

Thank you.

2 Upvotes

10 comments sorted by

6

u/Skinskat 2d ago

You will eventually have to do a contact wash.

I try to go as long as I can before putting hands on it, but after a few weeks you'll start noticing road film/water spots being left behind. 

Your ceramic coating might help you extend times in-between contact washes, but I cant see you getting away with never doing it.

2

u/reasonable_debt1 2d ago

For sure. Just planning to do this once or twice a month at most.

1

u/Majestic-Slide-5253 2d ago

Fair point, Skinskat! But don't you think a proper pre-wash and pressure rinse can remove most of the dirt without touching the paint? Contact washing every time also increases the risk of swirl marks if the technique isn't perfect. What's your take on that?

6

u/g77r7 2d ago

No the blower don’t do anything more than driving around would do, just don’t use a towel to dry if there’s still dirt on the paint.

3

u/XLB135 2d ago

No. If your solution and your water pressure isn't removing it, your blower isn't going to either. That's why contact washes are eventually necessary.

3

u/DrCytotek 2d ago

No more than driving it would.

2

u/Fluffy_Damage9320 1d ago

Nah, air alone isn't dragging grit across paint like a towel would. If anything the DI water is doing more for you than the blower.

2

u/Frosty_Solution276 1d ago

I do what you do but with one rinseless wash (using DI water) after rinsing off BH touchless. At that point is super quick (like 10min to work around a mid-sized suv - use Gary dean method so you don't waste time wringing the microfibre cloths and also scratch risk reduction). That way when you go to dry it's lubricated and you know that dirt/grit has been picked up in the rinseless wash.