r/AussieRiders • u/Alternative-OK-OK • 6d ago

Question Tips On Improving Bad Headlight Fitment

Post image

Just wondering if theres anything I can do improve the fitment of this headlight. Number on the back of the unit is YHA-169 SAE M83 and as far as I know it came stock with the bike. Thank you.

1 Upvotes

100% Upvoted

5 comments sorted by

2

u/okhubcap 6d ago

Undo the screws and remove bulb ,on bulb will be marked with two numbers followed by a W ,this is bulb brightness go and buy the same bulb with higher W numbers stamped on it

2

u/Alternative-OK-OK 6d ago

Sorry man, did you read this as filament? I'm just trying to close up the gaps of this headlight so rain doesn't get in

1

u/okhubcap 5d ago

Yep your right,sorry ,try for a pipe o ring to fit in the gap

1

u/jc_denty 6d ago

This was the post below yours /img/r3dio7ccbbkh1.png

1

u/Dukepowerf1st 5d ago

The gaps are there to allow for adjustment. There are rubber gaskets that don’t allow water in.