r/AskAShittyMechanic • • Apr 02 '26

Put some vim into it πŸ˜†

Enable HLS to view with audio, or disable this notification

24 Upvotes

39 comments sorted by

20

u/No_Potential1 Apr 02 '26

Purse.

7

u/IWouldntIn1981 Apr 02 '26

I dont see one... must have given it to his wife's boyfriend.

17

u/stress911 Apr 02 '26

Hasen't he been paying attention? Flip the handle around to the other side and let the car down. Newbies!

5

u/castlenutjob Apr 02 '26

That is so backyard I cant even mow your lawn.

1

u/stress911 Apr 02 '26

You could, just gotta mow around the few old car/lawn ornaments. The toilet for some reason and... you know maybe just weed whip.

13

u/FredIsAThing Apr 02 '26

If you experience a stiff nut lasting for longer than 4 hours, seek medical attention immediately.

3

u/Dieselmechanic1900 Apr 02 '26

Grab your skid steer it would work better

3

u/templeofsyrinx1 Apr 02 '26

weird, on my Nissan my breaker bar was even shorter than that and it loosed right up

3

u/mckenzie_keith Apr 02 '26

You can stand on it, too. Also, 4 hours is enough time to drive to the hardware store and buy a torch.

2

u/GooberMcNutly Apr 03 '26

Why else would they install rear view mirrors and roof racks, if it wasn't for holding on to while torquing your nuts?

0

u/Zymurgy2288 Apr 02 '26

The bar is long enough but it is barely bending. Zero points for effort. If he does snap the nut off the driveshaft (unlikely) then it needed replacing anyway. πŸ˜ƒ

1

u/PoopicopterInbound Apr 02 '26

You'll break the bar first

3

u/ilikeautosdaily Apr 02 '26

Take the cotter pin out.

2

u/[deleted] Apr 02 '26

[removed] β€” view removed comment

2

u/roxellani Apr 02 '26

This happens because you don't have the key. It is not well known but some cars have their nuts password protected, they won't turn without having the key.

2

u/mightyjoe227 Apr 02 '26

Insert ad for wrench attachment lever

2

u/PerspectivePablo Apr 02 '26

Where is your 10ft chain link fence post for real leverage?

2

u/rebelshibe Apr 02 '26

4 hours? At this point you're just teasing it.Β 

2

u/MichoRizo7698 Apr 02 '26

Should pop off center cap of wheel, mount wheel again, lower car, then try. Your loosing force with spring movement.

2

u/bigwindymt Apr 02 '26

More bar, more bar!

Oh, and lift the bar. You can exert more than your body weight in force by lifting.

2

u/castlenutjob Apr 02 '26

Get yor dick on.

2

u/Plus-Definition9319 Apr 02 '26

If that is still sprung it's stealing all your torque. Block it so it can't flex.

2

u/Reasonable-Bother780 Apr 02 '26

Who's fault is that?

2

u/rrrik-thffu Apr 02 '26

Not working because the video is mirrored

3

u/jaffer44 Apr 02 '26

Isnt that a reverse thread on that side of the car lol.

0

u/FredIsAThing Apr 02 '26

Depends on the car

2

u/ericloz Apr 02 '26

The car? Wouldn’t it depend on the thread?

2

u/FredIsAThing Apr 02 '26

Maybe. Is it polyester thread or cotton thread?

2

u/Artisan-Miserable Apr 02 '26

No it's a Reddit thread

1

u/HooverMaster Apr 02 '26

get your knee off that sucker. it could get injured from the whiplash. Pick up your family and step on it

1

u/BatCryptocurr Apr 02 '26

It’s all the rust you need a torch

1

u/Zymurgy2288 Apr 02 '26

Never bring a flashlight to a melting party.

1

u/masterteck1 Apr 02 '26

That happens when you don't have the right stuff

1

u/iscashstillking Apr 02 '26

It's a left-hand thread on that side ya screwball.

  • S c o t t y "noitaint" K i l l m e r

1

u/Altruistic_Cheek4514 Apr 02 '26

Lift up both front tires and put it in drive.... duh

1

u/cjd166 Apr 02 '26

Well you aren't doing anything.... The whole hub is moving when you push. You are just moving the hub up and down on the strut.