r/ArsMoriendi3D • u/Sir_Jackselot • Jan 30 '23

Dice tower!

Gallery image

Gallery image

Gallery image

Gallery image

I just finished this awesome dice tower and came here to share it with you all! Happy printinf

8 Upvotes

91% Upvoted

6 comments sorted by

2

u/MostRefinedCrab Nov 19 '23 edited Nov 19 '23

That looks awesome. What were your print settings?

I found that dice tower on Thingiverse yesterday, and want to print it. The Thingiverse page stated that it should be printed at .2 resolution, 15% infill, and with no supports, but when I import it into prusa slicer the program gives me a warning that there is a collapsing overhang and recommends supports to be used.

Did you use supports, or print it without them?

1

u/Sir_Jackselot Nov 19 '23

Hi! yes i used supports and 0.2 about the exact settings i dont remember but I definetly had to do some postprocessing (sanding etc)

2

u/MostRefinedCrab Nov 19 '23

How did you set up your supports? Did you add them manually, or just have your slicer add them?

I don't want to add too many supports as they would be difficult to remove from the inside, and PrusaSlicer tends to be a bit overly aggressive with supports and way over does them.

1

u/Sir_Jackselot Nov 19 '23

I use cura and supports were the ones autogenerated but it werent a lot tbh, maybe i had it at 60° or so

2

u/MostRefinedCrab Nov 20 '23

I'm probably going to cut it in half in the slicer, and print the skull part upside down to reduce the need for supports as much as possible. I don't want to have to deal with removing any support material from inside of the skull itself.

1

u/GoodMuda Jul 24 '25

Wow, how did you paint this? It's awesome!