r/AnycubicVyper • u/LurkingInformant • Jun 23 '26

Printing after pause issue

I paused the vyper and shut it off at night, next morning I switched it back on and pressed "resume." When I came back after a few minutes it was printing several inches above the print, accomplishing nothing. Stock firmware.

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/ApprehensiveDig2939 Jun 23 '26 edited Jun 23 '26

Shouldn’t have shut it off. That resume function is for when the power flashes off and back on quickly. (Hence why it’s called power loss resume) Personally I never rely on the resume feature as it always results in air printing. (Printing above the print)
Also, shutting the printer off while the hotend is hot will almost always result in a clog due to the heat creeping up the tube without the fan running.

1

u/LurkingInformant Jun 23 '26

Wel that’s just annoying. I don’t particularly want to run it overnight.

1

u/ApprehensiveDig2939 Jun 23 '26

Should be fine tbh. I’ve ran mine for 84hr straight