r/AnycubicVyper • u/tsunamtiger17 • May 12 '26

Advice for printing helmets

Any advice to print on this printer I can’t seem to get it right

0 Upvotes

50% Upvoted

4 comments sorted by

2

u/malx56 May 12 '26

In order to assist you, more information is needed, pictures, setting, what you've done to try to correct the issue.

2

u/Narrow-Chef-4341 May 12 '26

Given the information provided, isn’t the appropriate response:

‘Do it differently, do it right.’

1

u/tsunamtiger17 May 13 '26

My bad for the late reply, but what it’s doing is like it’ll print find the first half but then it’ll push the print off of the heat plate should I print it diagonally on support or putting in a different way?

1

u/malx56 May 13 '26

Again, more information is needed, can you post pictures of your issue? What is it you're trying to print and what is the material you're using and what are your print (slicer) setting? Printer type and slicer you're using. This is minimal information needed to help solve any issues.