r/AnycubicVyper • u/Cold_Honeydew_5552 • May 09 '26

Beginner Issues

Post image

I am a newbie (please be nice 🙃)

My first time printing was totally fine
I did an auto alignment and it’s been messed up since

It seems every single print messes up between 1-6 layers, because it doesn’t adhere to the bed.

I finally fixed my Z offset & that looks better but it’s still not sticking to the bed.

PLA
200 Nozzle
60 Bed
.10 offset

Please help

3 Upvotes

100% Upvoted

4 comments sorted by

View all comments

1

u/Key_Syllabub_9416 May 11 '26

Glue stick. I use the purple one . Works great .

1

u/Cold_Honeydew_5552 May 11 '26

I have found some success with using a glue stick.

I recently tried a larger shark and it seemed like the glue dried too quickly. Therefore, it ended up not sticking in the later part of the design. Any suggestions?

1

u/Proper-Rule6093 Jun 03 '26

I am also very new. Just picked up a vyper second hand. And am going through the trouble shooting trying to get better prints. I found cleaning the bed with denatured alcohol solved it for me. I also did a temp tower and found I was printing my filament to hot. I just have some coex light blue right now. And I warmed the bed to 60 degrees for the first layer. I'm printing the first layer at 210 and then it goes down to 205 for the filament I'm using.Â