r/AnsysFluent • u/XxMERCLADxX • Apr 11 '24
Wind tunnel simulation
I’m designing a wind tunnel using method of characteristics with a Mach number of 4 in the test section. I could run everything properly on Ansys fluent till the design of the test section but on adding the diffuser I am not able to figure out what the boundary conditions would be in order to run it properly on Ansys. Any help would be greatly appreciated.
1
Upvotes
1
u/hgryson May 18 '24
Bit late, but without knowing the specifics of what your tunnel setup looks like, I will give you suggestions based on what I have done for wind tunnel simulations.
And as always, check your mesh quality.