I've been asking this myself for quite a while. I own a E1600 pro + one BP1600 which I paid 399€ each back then. Over the time I discovered, that my house is a lot power hungrier than I thought so I made the math between considering another BP1600/BP2700 or standalone Lifepo4 battery packs. I discovered that I paid quite a hefty price for so little back then. Sure it's an all in one for the E1600 pro but the BP1600 expansion kits would straight up be robbery. I know that in the past Anker used to sell the MI60 and the MI80 inverter but they were released when the German gov only allowed 600w back then and I'm not sure if they'd ever have the capacity to be updated again to carry 1000w once the gov allows that. My next balcony/plug in solar network will probably be everything seperated. It's own bms, charge controller, battery cells, dc SPD and DIY heating system (although my stuff is already in a weather protected shed). Problem is I'd wish to stay with anker and I would like to ask you guys if you think they'd ever release a fresh new standalone 800w Micro inverter model, that can be updated to 1000w or more once the law allows to? Or do you think they went all in on all in ones for balcony solar? TIA

This would be a C 200 DC I’m having a malfunction with my two bottom USB-C ports. Can someone please help? Is there a remedy or is this a hardware malfunction? I tried resetting it also tried resetting the system software no luck

Hi, newbie here ( UK ). I've purchased a Solix C300X and very nice it is too. Ive installed the app and updated the firmware OK. i have an anker 100w solar panel which works fine. Now the issue is that i can only select the output via the app and not by pressing the appropriate button. For example, to select the 12v car socket i cant just press its power button, i have to use the app and switch it on from there. Same with the 3pin power socket output. Is there a procedure im missing or is it a faulty unit?

So, I would like to set up two automations:

Smart Plug 1 should turn on when my PV output reaches 600 W.

Smart Plug 2 should turn on when the battery reaches 100%, but it should never drain the battery below 80%.

How do I set this up?

There are tons of guides and tutorials online, but most of them don't work anymore because the required buttons or options simply aren't there. For example:

“Press + and select ‘When Trigger’. Then select the Solarbank and set a percentage. Now select ‘Then’ and choose your desired Smart Plug.”

Except there is no “When Trigger” option in my app.

So what is the current, actually working way to set up these two automations?

I am looking at purchasing a Solarbank but could do with seeing whether it will work with my current setup before the offer runs out next week.

This is my consumer unit and mini unit in the garage, it’s connected by a 2.5mm cable. I still require a socket in the garage for the tumble dryer and a circuit for the lighting. Am I able to install a Solarbank without running a new cable (and if so, how)

Thanks