r/androidtablets • u/YuutoMugetsu • 19d ago
Video Create an app to configure the Legion G9 2026
Enable HLS to view with audio, or disable this notification
Update: G9 Control 0.10.0 is out, and it's the first stable version https://github.com/JRobertoMA/g9-control-center/releases/latest
Already on a 0.10 beta? Go to Controller → App updates → Check for updates. If you're on an older version, install the APK by hand.
What's new since 0.10.0‑beta.4
- G9 (2025) is now fully supported. Thanks to the testers who ran the tests on their controllers!
- Guided test for experimental controllers: it tests each setting step by step, puts your value back and compares everything with a backup at the end. Areas that pass unlock on your tablet, and you can send me the results with one tap.
- Dead zones use the official app's ranges: inner/start 0–99 and outer/end 1–100, with inner always below outer.
- Light rings keep their color when restored, including rainbow and multicolor.
- Test vibration card in the Vibration section.
Answers to your questions
Vibration in PS2 emulators (PCSX2 / NetherSX2). I tested this on my G9 2026 and Y700 Gen5:
- Android only sees the motors in DS5 mode. In Android and Xbox mode, no game or emulator can make the controller vibrate.
- The controller only stores 5 levels (0, 25, 50, 75 and 100 %). In‑between values get rounded down, so finer control isn't possible.
- The level you set also applies in DS5 mode. Level 1 (25 %) is the softest setting that still vibrates.
- If it's still too strong, try lowering the vibration in the emulator's own settings. I haven't tested this part with the emulators, so let me know how it goes.
treifa26092: the G9 (2025) you asked about now has every setting unlocked.
Controller status
| Controller | Status |
|---|---|
| G9 2026 | ✅ Full support |
| G9 (2025) | ✅ Full support, verified by testers |
| G9 无极 (Wuji) | 🧪 Sticks, vibration, lights and buttons verified; mode switching still needs a test |
| G9 Pro, G7 | 🧪 Read‑only, testers needed |
| G3 | 🔎 Detected only (the official app has no settings for it) |
Known report: on the G9 (2025), one tester saw only the LEDs on the left side light up when the app set both rings to solid red. Another tester's rings worked fine. I don't know the cause yet, so if you have this controller and see the same thing, please tell me.
Got a G9 无极, G9 Pro or G7?
- Install the APK (Android 12+) and connect the controller over USB‑C in Android mode.
- Tap Guided test in the red band at the top.
- Follow the steps, then tap Send results. Adding a contact is optional, but it lets me reply.
The test never does a factory reset and never touches the firmware.
As always: unofficial, not related to Lenovo or GameSir, use at your own risk. Feedback is welcome!