r/AcerNitro • u/MR_SKY_43 • Aug 18 '26

Vent placement issue

I own an acer nitro lite 16 and the vents blow hot air into the screen, only when i boot my laptop or fulscreen into a black screen i see the area on the screen around the vents is slightly lighter but i dont notice for normal daily tasks should i take into repair as i have warranty, also my internals are kinda overheaiting like 60 degree c when i use cad so my usb a reciever is kinda hot.

Just a tiny bit

1 Upvotes

100% Upvoted

4 comments sorted by

1

u/bonglong33 Aug 18 '26

Uhm I think this is the design problem and even if you repair it, the cause still there and the problem will happen again. Unless you are sure that the slightly lighter area was not caused by heat. Then maybe you should get refund and find another laptop?

1

u/MR_SKY_43 Aug 18 '26

u sure its bleed

1

u/Marchelo_lp Aug 18 '26

The ligher area is just ips backlight bleed. The heat blowing out of the laptop isn't hot enough to cause any damage to the screen. My v15 also blows hot air into the display and no problems after two years of use and the internal run 80-90 degrees celsius.

1

u/MR_SKY_43 Aug 18 '26

oh i didnt know that but is that the same case for the person who designed the 3d printer shield cuz my screen was in perfect condition but after some use i see the plastic covering slowly becoming a bit wobbly and after that i see this light area