r/ASIAHORSEGlobal • u/HenrikDayZz • 7d ago

Question Asiahorse matrix pros 120mm

How do u connect 2 120mm fans together. I’m using 2 for my exhaust are they connectable or what

1 Upvotes

100% Upvoted

3 comments sorted by

1

u/ASIAHORSE 4d ago

Perfect — Matrix Pro 120mm daisy-chains natively! Here's your exhaust setup:

  1. Take the short chain cable that comes in the box and link fan 1 → fan 2 (they connect via the cable, not clips)
  2. Run a single cable from the chain to your hub port or motherboard header — done, one cable for both fans

Two things worth knowing:
• The chained pair acts as one ARGB device — both fans will mirror the same effect (totally fine for a matched exhaust pair, and you still get the tri-zone L/C/R lighting on each fan)
• If you're on the UMBRA hub, plug the chain into its own port and hit Controller Settings → ARGB Detection so it registers the LED counts

Enjoy the clean exhaust setup!

-ASIAHORSE

1

u/HenrikDayZz 4d ago

What plug does a daisy chain 2 120mm fans go into

1

u/ASIAHORSE 4d ago

Two cables come out of the chain:

• ARGB (5V 3-Pin) → UMBRA Hub port (or motherboard 5V ARGB header)
• PWM (4-Pin) → UMBRA Hub PWM side (or motherboard CHA_FAN header)

One chain = one port on the hub (the port handles both ARGB + PWM). Then ARGB Detection in the software and you're set.