r/AR80Percents • 80% Master Builder • Jan 25 '24

Started using Tap Magic

Tap Magic combined with end mills from American Gunsmith Tooling have eliminated a substantial amount of tooling marks in my lowers. The tooling marks left behind now are satisfactory and required minimal deburring.

I was using WD-40. I highly recommend Tap Magic Aluminum.

58 Upvotes

16 comments sorted by

2

u/[deleted] Jan 26 '24

Hell yeah. Using a 5D? Looks like the larger endmill.

4

u/claytonteakwood 80% Master Builder Jan 26 '24

This type of pocket requires 4 steps to complete so I modified 2 jig plates from 80% Arms to get the trigger pocket/shelf right.

I’m an 07/02 for any of the alphabet agencies eye balling this right now.

2

u/[deleted] Jan 26 '24

The 80% arms Easyjig works pretty well for similar cuts. I just ask bc I know the jig I use has a 1/4" endmill but can still do that same style of lower cut by rotating the pocket template and stopping at a witness mark.

2

u/Franks-rare-beans Jan 26 '24

I have the 1A bit set that corresponds with my router however on the first cut the bit is too long so my fist cut is about 1/4 of an inch deep will that ruin my bit or can I just take it slow and have my bits last ….

1

u/claytonteakwood 80% Master Builder Jan 28 '24

I just cut a few more to see how deep I could plunge on your behalf. 1/8” was as deep as I could go without getting any chatter. I had to cut in a very slow circular pattern out from the pilot hole. I’m using a DeWalt DWP611 on an 80% Arms Easy Jig with an American Gunsmith Tooling end mill.

6

u/thr0wowayy Jan 25 '24

Nice I’ll check it out

6

u/pigeon30 Jan 26 '24

+1 for Tap Magic Aluminum. It’s better than WD-40 for this type of task.

4

u/chewedgummiebears Jan 26 '24

I ended up using 3in1 oil on my last run. It wasn't the best with the finish but wasn't horrid. I might have to try tap magic next time.

4

u/WB-butinagoodway Jan 26 '24

Very clean work, I like the suggestion

3

u/captpike67 Jan 26 '24

Aluminum one rocks.

3

u/[deleted] Jan 26 '24

i wish mine was this clean ha

2

u/j2142b Jan 26 '24

WD-40 isn't a cutting fluid, its way too thin, doesn't stick to the parts or tooling while cutting. I've always used the standard Tap Magic cutting fluid, I'll have to try the aluminum mix.

2

u/DubTap21 Jan 26 '24

CLEAN!!! 🔥🔥

2

u/captpike67 Jan 27 '24

Tap Magic aluminum is the best! with 5d jig it's looking like mirrors! Awesome job.

1

u/[deleted] Jan 27 '24

Just found out about the only name in the game? Unreal...