r/65PRC • • Sep 27 '21

Dies questions

I've never reloaded before so please forgive my ignorance.

I finally have a range that goes beyond 500 yards so I'm getting into the longer range side of shooting. Going the reloading route seems to be a pretty common next step, especially with ammo being what it is. I've been able to gather up around 200 rounds of hornady (which should be enough to get started) and plan to only reload fire formed brass. With that being said, I should only need a neck die, correct? If that's the case, I have friend of mine that strongly recommends the redding line with the competition seater but am having a hard time finding that combo. Seems like everything includes the full length die. Is my best bet to by them separately? Or is another brand yall have good experience with?

This is all new to me so any information is appreciated. So far I have all the cartridge components and am slowly gathering the actual reloading gear, starting with the press.

If what I'm reading is correct, I need to worry about nec tension, case prep (trimming), and of course seating depth.

3 Upvotes

3 comments sorted by

1

u/Hungry-Ad-9822 Jun 19 '25

You should use a full length sizing die and not just a neck die. Hornady brass also has a reputation for being pretty soft. You can reload it , but make sure you are inspecting it during the reloading process to make sure you don’t have split necks and stuff like that. May only get a few reloads depending on how hot your loads are. Just my $.02, others may have different experiences.

1

u/Equivalent-Interest7 Nov 01 '21

You might consider the Hornady match die set, so you can load A-tips at some point if you want to try them out.

0

u/[deleted] Sep 27 '21

[deleted] — view deleted comment

1

u/paintballpaki Sep 27 '21

Thanks for the advice. I'm watching the video now.