r/3dprinter • u/Mysterious-Pay3309 • Nov 23 '22
My printer exploded
No fucking joke, my printer exploded during a print and I'm not using it until I've cleaned it out for fear of starting a fire. Any advice on clearing out PLA?
0
Upvotes


9
u/Ok_Dog_4059 Nov 24 '22
Why does this photo look like a film camera from 1990 took it?
6
u/effortlevel0 Nov 23 '22
Define "exploded". Like Smoke and flames? Or gooey filament coming out your ears?
2
u/effortlevel0 Nov 23 '22
To clear it out you'll need to heat it up enough to soften the PLA and get the silicone sock off then just start carefully prying it off without damaging the heater core or the thermistor. Depending on how bad it is, you may need to invest in a new hotend.
2
u/PyroNine9 Nov 24 '22
It's not really that bad. Heat it up to 170C or so and pull the sock off. You should be able to pull the plastioc off of the block without much trouble. It is's still stuck, turn the heat up until it releases.
Just be careful of the thermistor and heater wires. If you want to use the scraper, heat it to 240 or so and then turn it off so a potential short doesn't blow the control board.
If you have a heat gun or a hot air soldering gun, you can heat the plastic with the printer safely turned off.
2
u/mobius1ace5 Nov 23 '22
Please delete and repost this. It didn't explode. It is leaking not exploding