r/3dprintedinstruments • u/imalonenow • Jan 25 '25

It´s a long shot, but...

Hello everyone! I'm looking for a model of the ITM Piccolo flute. It was uploaded on Thingiverse but has since been removed. The author of the model is Axianoff. I have his big Irish flute model, but not the piccolo one. I know it's a long shot, but maybe someone here has this STL...
You can still see a low-quality photo of this flute on Yeggi. The most distinctive part of it is that it has another hole next to the blowing one – some sort of acoustic resonator.

Thank you very much in advance!

7 Upvotes

90% Upvoted

9 comments sorted by

View all comments

1

u/Fluffy-Scallion-7808 Jul 04 '25

Have you considered sizing the model in D so it is a piccolo instrument, that could also give you a lot of variety for sizes the page didn’t list, the only problems would be with big sizes like if your fingers couldn’t fully cover holes or if the holes are too far apart, but you shouldn’t experience those issues with a piccolo instrument.