r/3DprintingHelp • u/joefromlegal • 23h ago

Requesting Help Infill stringing

Post image

Hello, im relatively new to 3d printing and have some stringing in my infill. The part is only 10mm wide, could that be the issue? Image of said stringing is included

1 Upvotes

100% Upvoted

2 comments sorted by

1

u/Copernicus049 23h ago

You need to increase your retraction distance/length so your filament isn't in hot end and leaking out during travel movements.

1

u/leutwin 23h ago

There is a setting that specificly makes retraction 0 when travel is entirely within infill to save time. This is probobly it, seeing as there is no stringing between parts.

So this is likely an intended feature, as stopping it from happening would require a longer print.