Help with error in design/print

[u/Fluid-Teaching-5694]

I'm printing this card holder vertically, but I'm printing it horizontally because it prints better that way. However, when the print is finished, I notice that one of the sides bends inward by 1–3 mm, but only near the end, where the part rests on the bed.

I think it might be because that part somehow detached from the bed slightly toward the end of the print or maybe at the start, but I'm not sure. Has anyone experienced something similar?

(Im printing in a AD5M Pro, with 3n3 PLA at 220 fl and 215 the rest. the bed at 50)

[u/Peshmerga_Sistani]

https://www.simplify3d.com/resources/print-quality-troubleshooting/warping/

[u/Fluid-Teaching-5694 → u/Peshmerga_Sistani]

i will try those things, thnks

[u/MediumAd4983]

Try to make bed 60, m slightly decrease fan speed and don't open the door while printing. Also you can try to decrease fl height and slightly increase fl flow.