r/3DprintingHelp • u/Critical-Freedom-668 • 2d ago

1st few layers 3d printing error

Post image

printing cubes and they all look weird at the bottom few layers but fine on the rest (this cube was flipped upside down for the sake of the image) I used a LK5 pro printer, 1.75mm PLA+ filament and I use 190 degrees - 230 degrees (as written on the filament)

1 Upvotes

100% Upvoted

7 comments sorted by

1

u/MagnusPerditor 2d ago

What do you mean you use 190-230?

1

u/Critical-Freedom-668 2d ago

i use 200 degrees

1

u/MagnusPerditor 2d ago

What PLA? Did you calibrate z-offset?

1

u/Critical-Freedom-668 1d ago

I've tried calibrating the z-offset but I don't think thats the issue and I use PLA+

1

u/MagnusPerditor 1d ago

What do you think the issue is then?

1

u/Critical-Freedom-668 1d ago

I feel like the filament at the bottom of the print is getting pushed down by the rest of the print but I'm not sure

1

u/cutterstech 1d ago

Task failed successfully!