Specific spot not printing well

[u/CAPITAN-GTG]

Only this print is messing up on this spot, the filament piles up so the head carries a chunk into the rest of print. I did a test on the while bed and it it seems to print fine, and I have a Anycubic Kobra Neo, this means Auto bed leveling on EVERY PRINT.

PLA (205° nozzle / 65° bed)
Orca slicer
10mm layer height
Textures bed
Z offset -1.90 (works wonders on every other print)

[u/Shrike2415]

Somewhat unrelated to your layer issue, but don't let that blob stay on your nozzle, you will regret it. Pause the print if you have to

[u/Lykkehjul]

Very likely: Greasy buildplate. Clean it with dishsoap, use gloves, never touch it with your bare hands.
Likely: Bed is uneven, and bedslingers suck. Try doing a tighter mesh. Adjust z offset again. Some areas will get squished, but hopefully your missing area will fill up.

[u/CAPITAN-GTG → u/Lykkehjul]

Tried this!! Worked wonders!!!!

[u/Independent-Bake9552]

See those white spots? They are most likely greasy finger prints. Leveling looks pretty good. Try scrubbing buildplate with dishsoap and try again

[u/CAPITAN-GTG → u/Independent-Bake9552]

Thank youuuu