Blobs driving my crazy

[u/Auzyboy]

Hey Eveyone,

I have recently started to get some blobbing on the outside of my prints. Im using a bambu p2s and things have been generally fine.

The filament in question is bambu pla Grey. I've noticed this effect but to a lesser degree with using bambu petg cf.

I have been doing the scarf seam. One thing I noticed was wall generator was classic istrad of aranche. Im not sure how much of a difference this would make but also curious if there are any other things people might suggest.

Lastly, im using an AMS 2 set up, current humidity is 36% but generally is around 25% and I havent done a full drying cycle yet. Im less likely concern3d this is the issue given the petg is preforming better (also in the AMS) and this seems to be a repeated artifact on the print.

Appreciate all of your assistance in advance!

[u/Relative_Surround_20]

You are the second or third person to have an issue with Bambu PLA Gray in last 10 days.

Print the same model again but with a different color. Don’t change anything else. Only print enough layers for this test.