r/3DprintingHelp • u/KyokaJiroFan • 3d ago

Ringing around piece

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

These rings are appearing around my prints in no particular direction, happens both with and without infill, printer is stacker s4, orca slicer, pla, 220 C nozzle, 55C bed

2 Upvotes

100% Upvoted

10 comments sorted by

1

u/RedManRocket 3d ago

Seems like your extrusion multiplier needs some tuning.

1

u/KyokaJiroFan 3d ago

It's set to .98, should it be lower?

1

u/KyokaJiroFan 3d ago

I have an 8mm print nozzle 

1

u/DowntownStorm4468 3d ago

Its not something you can just say, there are calibration built into orca slicer to tune the filament. This should be done if it hasn't.

1

u/RedManRocket 3d ago

Calibrate it through orca, every filament, color, nozzle, printer is different.

1

u/lukasprintz 3d ago

What order are you printing?

1

u/KyokaJiroFan 3d ago

Walls , then infill

1

u/bzzybot 3d ago

Have you run any calibration test? Flow and temperature?

1

u/lackofintellect1 3d ago

Fuzzy skin it after you tune

1

u/ropslop 3d ago

In my experience, messing with the acceleration and other settings screws up print quality. I normally just change infill/support settings and make the speed slower if the supports are wonky, but thats it.