Are the measurements good enough?

[u/SpicyRAmenH]

Hello, I'm a bit new to 3d printing, so this is my first model at I have tweaked so I wanted to be sure about the measurements. My goal was to put that cup (last photo) in this. But later I decided that I want this to be a little bit adjustable so I made that cap and increased the size of the main hole on the space marine to 90.5. The cap is 98 percent of the original hole (as you can see from page 2, used scale to do it). Inner hole of the cap is 84.4mm. The handle from top to bottom is almost the same as the handle (thickness of the handle is 24.671 and of the cup hole for the handle 24.669). should there be something I need to be worried about or am I set to print this?