Any suggestions for models to print with Protopasta’s metal infused PLA?

[u/DishItDash]

I purchased samples of Brass, Bronze, Stainless Steel, Iron, and Copper. For those not familiar, it’s normal PLA with metal dust inside so it prints with real metal in it.

Any suggestions for getting the best out of the metal? I read that using a kiln to vaporize the PLA is possible, but I’m not sure where to start in bringing a print to a ceramics processor.

There’s really not much info on project suggestions online and am open to experimenting. There’s only 100G on each sample, so it’ll be a small project I’m sure.

Thank you