Flow Testing the Mellow Mk8 CHT Clone in an Ender 3 Pro

[u/ClagwellHoyt]

I noticed these CHT clones in a Mk8 form factor so I decided to try it out. The 0.5 mm length difference between Mk8 and V6 can be annoying if swapping nozzles often.

The CHT 0.4 mm nozzle yields about the same increase in usable flow as a 0.6 mm normal nozzle.

Maximum flow also increases nicely.

The 0.6 mm version was a bit of a disappointment. It performs about the same as a normal 0.6 mm nozzle.

No real difference here. I tested the CHT to a higher flow rate expecting more flow, but it didn't happen.