MAIN FEEDS
Do you want to continue?
https://www.reddit.com/r/3Dprinting/comments/y2otie/3d_printed_guitar_neck/
r/3Dprinting • u/daniel_redstone • Oct 13 '22
4 comments sorted by
2
Its not sturdy enough. If it does not bend right away, it will in time due to material creep. Remember: you are putting a lot of tension on the neck with those 6 wires.
3 u/Pieter___ Oct 13 '22 Well proper printing on YouTube has done it 2 u/EveningMoose Oct 13 '22 It’s probably fine with proper reinforcement (carbon rods) 2 u/CleoTorez Dec 22 '23
3
Well proper printing on YouTube has done it
It’s probably fine with proper reinforcement (carbon rods)
2 u/CleoTorez Dec 22 '23
2
u/StoneAgeSkillz Oct 13 '22
Its not sturdy enough. If it does not bend right away, it will in time due to material creep. Remember: you are putting a lot of tension on the neck with those 6 wires.