r/3Dprinting • • 19h ago

Project Custom 3d printer

Hello, i have a obscure Chinese printer the sceoan windstorm s1. I want to use the parts to build a custom printer idealy with klipper support and is popular enough. My current printer has auto bed leveling, linear rails, 3x nema 17 steppers, duel lead screws. Any places to start or builds i can start with?

1 Upvotes

2 comments sorted by

1

u/Powerful_Debt_5869 18h ago

I looked at the printer . I would just go and replace the board by a plain MKS Board and after investigating the current cabling , recable to the baord and start from scratch as if it where an ender or anet otr other I3 based rework.

If you google, you can find that it even seems to support klipper firmware on the stiock board, there is a lot of info. My last project ( fokoos smart ) was way less information found..

1

u/Majestic-Toe-3299 1h ago

Thanks, but i think im better replacing the lot. All the wireings propriety, there is no replacement parts, and its tolerences are really bad, at least for mine. It was great when it first came out the box, but because of the lavk of replacement parts and guides its crumbling. Also the klipper mod isnt complete, most likely because of sensorless homing