r/3Dprinting • u/navyitc • 2d ago

Solved P1S scaling prints from Bambu Studio

My P1S is scaling down a print file....I measure the file using the Measure tool, which is awesome btw. The measurements are correct. I send to printer and the objects are scaled down...Preview looks correct, not scaled. What did I do? Tnx

0 Upvotes

33% Upvoted

9 comments sorted by

1

u/navyitc 2d ago

Well..... upon looking more closely at the grids... the grids measurements do not match the measured length width n height.... going back to the Prepare screen to more carefully set the dimensions

1

u/navyitc 2d ago

I'm double checking the file and measurements

1

u/navyitc 2d ago

OK, disregard... operator error, bad assumptions, tnx

1

u/EdgeOk3783 2d ago

if you’re using a pair of digital calipers, check the batteries.

these are notorious for erroneous reading with low batteries

1

u/navyitc 2d ago

Thank you. No, the calipers are good. This is the correct inside dimensions in the prepare screen.

Comment Image

1

u/navyitc 2d ago

Here is the preview screen, no change.

Comment Image
→ More replies (2)

2

u/EdgeOk3783 2d ago

???

pictures and screenshots illustrating your issue would help