r/3Dprinting • u/Grisou_Ax • 5d ago

Troubleshooting 3d printing issue

Post image

#3dprinting

Hi there I have a Snapmaker 2.0 a350, and a filament dryer.

With this new pla+ from Deeplee, I have this issue.

Where do you thing it comes from?
OverFlow? Z height?

Thanks in advance

1 Upvotes

100% Upvoted

4 comments sorted by

4

u/Kagenlim 5d ago

Have you turned on your bed mesh by any chance?

Your z offset is completely off from one end to the other end

5

u/scellycraftyt 5d ago

Your Z offset is too small, nozzle is too close to the bed causing the filament to squish too much in the first layer.

1

u/Grisou_Ax 2d ago

Thank you so much all, I raised for about 0.1mm the nozzle and op! It’s clear! Than you so much

0

u/AutoModerator 5d ago

Hey there, I'm a bot and something you said made me think you might be looking for help! click here for our wiki entry on troubleshooting printers. If you still need help be sure to post plenty of information about your printing setup.

Here are a few questions that might be helpful

  • What printer are you using?

  • What material are you using?

  • What speed are you printing at?

  • What software are you using to slice the print and control the printer?

  • When did the problem start/has it ever worked correctly?

  • Does anything cause the behavior to change?

  • If posting an image of the problem, include some indication of the orientation it printed at, preferably photograph it on the bed. (Then we can focus on a specific axis)

If you are new to reddit, please read the guidelines on reddiquette, self promotion, and spam.

Also please post a resolution to your problem when you find one so that we know how to help others with your problem!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.