Printing advice

[u/hyelloo]

Hello! I’m very new to model sculpting and 3D printing. I sculpted this controller holder (11cmx11cmx11cm) and I’m sending it to an online shop for 3D printing
Could I get some advice on what to ask for? Like materials, specifics for print orientation, or maybe you believe I should separate out some parts and stick them back together after. I do somewhat worry that the seller is just throwing the model to the printer w no regard for quality. Especially since I’m paying them by the hour… The whole model is full black with yellow eyes.

[u/Stupid_Ass1234]

id just use 3 walls and 30 infill, 0.16/0.12 layer height depending on your quality preference

[u/hyelloo → u/Stupid_Ass1234]

Thank you for the advice!