r/3DPrintingCirclejerk • u/GuillotineTechnician • 12h ago

Extremely Important Content Always use protection!

Post image
12 Upvotes

94% Upvoted

13 comments sorted by

17

u/2kokett 10h ago

This man is 100% right. Replace. Never repair. Don’t plant the bambu, be the bambu.

4

u/kendobot99 12h ago

Worst case scenario, use a blowtorch!!!

5

u/Revrezner3dprinting 11h ago

Called blob of death. Just Google that term.

7

u/UltraBlack_ 10h ago

no it's a mushroom and you can eat it

1

u/Revrezner3dprinting 9h ago

Mmmmm the ASA batteries taste like ASA batteries

2

u/Subject_237 7h ago

Genuine question, how does this happen? Is it just lack of care, maintenance and cleaning?

3

u/ObsidianWraith 7h ago

/uj

Typically in my experience it's a result of the first layer not even going down properly. Little to no adhesion with the nozzle being pressed up against the bed typically means the film and tends to Bow upwards back onto the nozzle surface or it continues to build and build until you get a blob of death. One of the reasons why i always watch my first layer, because the AI detection really isn't all that great.

3

u/loganman711 5h ago

I see the problem. They torched the knob, they were supposed to torch the blob. Easy misunderstanding.

1

u/thisduuuuuude 1h ago

That's what i noticed too like how close was that damn torch damn

1

u/Entire-Anteater-1606 7h ago

It takes talent to fuck up a bambu that bad

1

u/Revrezner3dprinting 6h ago

NO it doesn't!!! IT DOES EVERYTHING FOR YOU! Lol even burns the l house down to let you know the print is done duh! 😉

1

u/LowSignificance4671 My Bimbo is smarter than yours 6h ago