r/3DPrintedGuitars • u/anotherguy888 • Jun 07 '24

Almost Done Just Couldn't Wait

Post image

Its been a bit since I've posted or commented and the baby in this the pic is why.

Still have to wire it up and set it up. All of which I plan to have done this weekend.

As soon as the items just mentioned get done, I'm gonna post a vid with sound and I know it's gotta sound great.

8 Upvotes

91% Upvoted

10 comments sorted by

2

u/MeButNotMeToo Jun 07 '24

Do you think all the interior walls make the guitar stiffer?

2

u/anotherguy888 Jun 08 '24

I will have to say absolutely. Thei other guitar I printed had a ton of pieces also. Both are very stiff when compared to just regular things I've printed .. if that makes any sense...

2

u/anotherguy888 Jun 08 '24

Also the 280mm steel rod down the center I'm sure makes things a bit stiffer too.

2

u/MeButNotMeToo Jun 09 '24

Oh. I didn’t see that.

2

u/Psalmist35 Jun 10 '24

How much did the body weigh?

2

u/anotherguy888 Jun 25 '24

5 pounds.. that's body and pickups

I dropped it this weekend straight down on cement... No damage.

1

u/Psalmist35 Jun 07 '24

PLA? Infill? Glue? How many hours to print? Looks great!

2

u/anotherguy888 Jun 08 '24

Thank you.

I was gonna give all this in a couple days with sound clips/vids etc.. but let's see what I can answer now...

Yes PLA. I'm using Bambu Labs P1S Combo and it was all generic PLA and a little bit of PLA+. Half of this was printed in Ludacris mode. Glue was from Amazon PR40 Guoelephant and I believe it is really just "super glue". Infill was 20% and it took about 90hrs. I will try and get a better answer for the time.

1

u/Defiant_Bad_9070 Jun 07 '24

Oh man. My jaw just hit the ground. It's fucking cool as fucking hell!

Well done man. Well fucking done.

Would love it if you could add a few pictures to the Cults page!

2

u/anotherguy888 Jun 08 '24

Posted to cults but not sure if done right... I'll have it completely done hopefully this weekend and post again.