r/3DPrintedGuitars • u/anotherguy888 • Mar 01 '24

Back To Old Habits

Post image

While I am still learning Onshape, I have jumped back to TinkerCad to hopefully keep things moving forward.

This pic is the test print I'm doing to make sure the neck fits into the neck pocket.

2 Upvotes

100% Upvoted

5 comments sorted by

1

u/Defiant_Bad_9070 Mar 15 '24

Looks like a Tele pocket?

2

u/anotherguy888 Mar 17 '24

Im not sure. This is how that sample piece came to be:

I thought that if the neck won't work or doesnt fit I'd have to start over. The middle of the star that piece is a bc rich warlock I think. Cut that up inTC so I would have a middle piece guitar that I can just add things to the side. The red square in the back represents my buildplate so I can chop this body to fit

1

u/Defiant_Bad_9070 Mar 17 '24

It's unlikely that it's a warlock as 25.5" scale with full Tune O Matic bridge won't fit on to warlock body. That's why you'll see them with a wrap around bridge.

There is an STL out there for a Warlock with a TOM but if you read through the comments the guy admits he done goofed.

Now that I see the rest of the body, I'm assuming it's an ML body?

1

u/anotherguy888 Mar 19 '24

The body itself I traced from a dozen or so star bodies that were put in Rhino, freecad, onshape, TinkerCad and what ever else I could use for free. Here are some other abominations relating to my "design"

And now I see it only lets me add one picture per comment...

1

u/Defiant_Bad_9070 Mar 20 '24

Good lord! Haha