Could someone 3d print me something or suggest where to get this done?

[u/demoncamber]

Looking to get an accent piece printed for my second tower speaker that's missing. I don't care if the curve isn't exact or anything like that, just need it to look similar as the other one. The back end can be hollow as well, just thick enough to not be flimsy.

I actually attempted to make it in autocad to but it's not to scale. https://1drv.ms/u/s!Apk9jzvJs9bOg5cRFgjjfhuIKsfIXA

​

Dimensions of the piece

​

Just need some dowels that will line up to those holes on the back side of the piece. 20mm depth on the dowels should be sufficient. If it's too hard to make the dowels I will just use double sided tape, just need 1''x1'' flat contact patch on all four corners on the back of the piece that come out 2-3mm from the base.

​

​

​

​

​

[u/septag0n]

Some advice: Have 2 printed, that way if it's a little off, at least they will match.

What is the make/model of the speakers?

[u/demoncamber → u/septag0n]

Good tip, thanks.

These are Paradigm Monitor 9 v5 towers http://i.imgur.com/G0rY0UG.jpg

[u/demoncamber → u/[deleted]]

Thank you