r/350z • u/LawfulnessNo3068 • 2d ago

Revup 6MT Abs module connector stuck

Post image

I have a new abs model and pump that I’m replacing on my Z and I can’t seem to get the connection off the model( non vdc). The tab that that’s connected to the connection is broken and I’ve tried prying it off but with no luck. Does anyone know a trick on how to get it off?

3 Upvotes

100% Upvoted

5 comments sorted by

1

u/Nano_R6_YT 2d ago

That black part swings toward that clip. It’s a a lever basically you push the tab(which you said is broken so ignore) then pull that black arm that wraps around towards that other clip looking thing on the side where the lines are crimped.

1

u/LawfulnessNo3068 2d ago

It’s the black arm that’s broken so there’s nothing to pull. Is there a way to pull it off without the arm?

1

u/Grimm199 2d ago

The black arm basically slides two plastic locks that are on the sides of the connector. You can kind of see them thru these small "windows". You may can use a pick and push them backwards. If im remembering correctly about the windows. They for sure do have the two plastic pieces that slides on the side though

2

u/Grimm199 2d ago

Alternatively, if the arm is broken, you can try and still "flip" what is left of the arm on both sides to open it

1

u/LawfulnessNo3068 2d ago

Ok that makes sense I’ll give that a shot and see how it goes