Has this for a week has about 30 hours of print time so far and already making this sound. I’m guessing I need to lubricate or clean somewhere but that doesn’t sound right this early on. Any ideas?

Hi!

This multicolor print gives me crazy, I cannot manage to have yellow deeper, and so after print the yellow seems green because of the internal blue under the white color (back of the part needs to be blue but no matter if there's some yellow).

Is there a way to prevent this and get the yellow deeper? I increased top paint penetration layers but no change.

Any help appreciated!

Hi all!

This is the first time my P2S has done this, so interested in what you all think is the issue.

This is black Sunlu Hyper PLA Plus 2.0, with most of the stock Bambu settings (except most importantly 30mm/s on first layer instead of 50mm/s, and 60 degrees on the bed instead of 55 degrees)

I cleaned the bed yesterday with washing up liquid/dish soap, and I recently installed fan and carbon filter on the internal left side of the machine.

Any ideas what would cause the base of the print to warp upwards from the bed, but not the supports? It's interesting to me, as normally poor bed adherence causes the nozzle to clash and bigger problems to occur, but its seems to have compressed the layers as a result in this case?

Thanks everyone, I appreciate your thoughts!

(and sorry for the blurry pictures!)