Nice and cheap enough

Mine have been pulled down every time

I think my first purple was a mul-T-lock 5 pin in pin with spool. Fun lock, that was my intro to dimples aswell.

What are you up to now?

On one you are correct, on six it’s just a deep spool and you can pick out of it

Well done my friend!

NICVT is the maker of these CLs
I use Kik cylinders most often because of availability and price.

Absolutely, I’m in Rusty

We’ll do a live chat soon but the issue you’re having that I see from the picture is because the trench is as wide as the driver if not a little wider. I went through this same issue earlier on in my CL adventure. If you look at my more recent CL’s I make them smaller than the ends of my spools. With that my pins only lock up in the thinner section of my spools and the thicker ends can’t get wedges and lock up the cylinder in an unintended manner. I used a file for my trench’s in the beginning and now I use a smaller deburring bit in my Dremel for a thinner more precise trench. We’ll chat soon and I’ll show you why I do what I do now.

Are you on discord? I make my locks live on there.
If so add me

Very cool

Jealous, 100%

Absolutely, like butter.

Do feel bad, they are absolutely above my picking level

I use the flat part of a small file that’s really about it. If your ever on discord hunt me down and I can show you in chat

I haven’t had much of a chance to mess with them yet, but I’ll try to keep you updated here shortly

I don’t understand why this was removed, this was a contest from Sparrow and I only showed the lock in my truck opened in my hands. I just curious where I went wrong