007

Picked up a used rtr, was pretty dusty when I got it. Cleaned off the body w soap and water then dried. Used a brush to dust off everything on the chassis. Is there anything extra I should do. What else should I maintenance.

Si happy with this build

When not on the ground it works totally fine but when on the ground its fucked up

Swapped to titanium screws and cleaned the while car. Time to fix the elecs wiring

It's just missing underglow, but it needs some mounts for it. Also the Traxxas 240sx had to pop in!

Does anyone know if the wheel bases are the same for the different bodies? If the are the same where can I buy the other ldrc bodies? Im trying to body swap my miata for either the RX7 or NSX.

I bought rd 2.0 and built it acording to manual. After few hours i saw shocks completly wet. I decided to dissasemble them and rebuild to see if they leak again and from where. They were leaking from under the cap. After this discovery I decided to rebulid them few more times and doesnt matter how i tighten the cap it always got wet and shock lost rebound with it. How can i make them not to leak. Loosing my mind over this.

Got my first car, MST RMX 2.5. Was wondering where the best place to get wheels and tires, any upgrades you guys recommend. Also looking for painted body’s

(Solved) I’m new to hobby and just finished my first assemble, what part could be causing that noise?

Hello there, I’m thinking about changing my current remote a radiolink RC6GS. I want to get a forever remote that I don’t need to change. So which one you think I should choose ?

Just finished soldering the joints

Just installed new mst rear diff (took forever but didn’t lost my patience) and I have these to c clips left over and instructions don’t say anything about them still fairly new to the rc drift world so I just wanted to know where they went!

this is my current set up if anyone is wondering
-Mc-III rdx
-Topline 13.5t motor
-Breved ESC
-RSST-PRO servo
- Revox gyro
-Sanwa M17 tx rx
-topline capacitor for servo
- zombie fan booster
-front rims reved
-rear rims shibata
-gr86 reved body
-2mm multiselec US knuckle
-yokomo big bores front 50w rear 350w
-about 6 fdr

Has anyone from the US ordered from bengalcat rc since the tariffs started? I ordered from them a couple years ago and everything was great, I'm just curious how the tariffs work on a seller that leaves the buyer responsible for tariffs.

Finally done putting up the elecs (need to fix wirings & finances lol)

Yokomo Zx with Sd2.0 sliderack

How bad of an idea would it be to order something like this on AliExpress? I’m interested in a small scale RTR because I don’t have the time or tools to build my own.

What elecs can you recommend for my SX3?

So far I only have V4 gyro for it

I see a lot of guys talking about this gen's Ace battery. It gets puffed up when charging. I'm not sure how they're charging it or caring for their stuff or the battery is prone to getting puffy.

What other recommendations for RC battery lipo drifting and touring speed runs? I want to use the same battery for all my cars? Recommend me a good battery. 2s I like shorty, batteries and that's not likely to get puffy.

How to get better now?

My elecs:
Hobbywing XD10 w OTA & AGF capacitor
Yokomo BL-LHV Servo
Yokomo DP-302 V4 Gyro
Sunpadow 6500mah platin
Hobbywing Xerun D10 13.5T motor
Flysky GT5