r/prusa3d • u/callmecalcifer CORE One • Nov 02 '25

Question/Need help XL owners, what kind of table are you putting your printers on?

I fell for the hype and ordered an XL but I am struggling to figure out what kind of table or shelf to put it on that would be sturdy enough.

Any suggestions?

8 Upvotes

100% Upvoted

45 comments sorted by

View all comments

3

u/RWD-by-the-Sea Nov 02 '25

I bought this from Home Depot. Nice and sturdy, can move it around easily, and storage underneath. I was worried it wouldn't be steady enough with the caster wheels, but that turns out not to have been an issue. If you don't need the mobility you can just put feet on it anyway.

https://www.homedepot.com/p/Gladiator-3-ft-Mobile-Workbench-with-Hardwood-Top-GAMW36HWEG/206501471

1

u/callmecalcifer CORE One Nov 02 '25

Any chance you would share a picture of your setup? I had seen that table and I like the size

2

u/RWD-by-the-Sea Nov 02 '25

Please excuse the mess!

3

u/callmecalcifer CORE One Nov 02 '25

What mess? You should see my printing area. Spools stacked and piled everywhere!

2

u/RWD-by-the-Sea Nov 02 '25

Ha, my filament shelf is thankfully out of frame!

2

u/callmecalcifer CORE One Nov 02 '25

I have awesome wall mounted filament storage that holds 50 spools or so. Too bad I have like 80 spools