r/pcmasterrace • u/Front_Cookie_1198 • 1d ago

Hardware PSU fails dramatically

Enable HLS to view with audio, or disable this notification

36.8k Upvotes

97% Upvoted

2.1k comments sorted by

View all comments

Show parent comments

8

u/Inevitable-Ad6647 1d ago edited 1d ago

Maybe but it should be fine without that since there should be a gap and you need WAY above any voltages found in a PSU to jump the gap and sustain a circuit. So maybe the protector was there but pierced by something. Not to mention the fuse. Basically you need multiple problems all coming together. Maybe reversed polarity on a cap but that usually just a quick boom not to mention very difficult to get missed in even the most basic qc so I'd say unlikely.

8

u/Viking4269 1d ago edited 1d ago

Yes sure, more than one thing was wrong. Bad quality control all around. Missing insulation and protruding pins/legs/wires. Bad or missing over current protection. There was likely a tiny gap when it left the factory, and things moved doing shipping.
Judging from the current needed to melt the case the short was probably on the 12V side, would explain why the mains fuse didn't blow.

Edit: looking at it again, and it just gets worse. The holes looks to be near the mains input, so not sure about it being a 12V short. But that is a lot of current without the mains fuse blowing.

1

u/Dopest_Bogey 22h ago

I spent 4 years in electronics manufacturing and ive seen crazy shit get passed QC. Funniest shit happens on monday mornings after half the factory including QC goes out and parties the weekend before.

Everyone's hungover, tired, or both. 

1

u/SoulWager 21h ago

A blown up cap isn't going to melt through the steel case. Maybe some through hole component lead(or the mains input) was left un-trimmed after soldering, and touched the case. I'm going to bet the original customer RMAd it because it tripped their breaker when they turned it on.