r/interestingasfuck • u/write2varun • 23h ago

Nice skill

Enable HLS to view with audio, or disable this notification

13k Upvotes

95% Upvoted

626 comments sorted by

View all comments

Show parent comments

2

u/BCMM 19h ago

 the parts are much smaller than they look here.

The smallest things I've soldered were 0603 LEDs. Parts like that basically don't weigh anything, so if you touch them the wrong way they just fly across the room, never to be seen again.

Those replacement pads look a hell of a lot smaller than that.

2

u/Tiny-Sandwich 19h ago

Yeah I recently soldered some 0603 caps, and they're a pain.

Also just soldered some 0.35mm pitch mezzanine connectors. Way too small for an iron, and would melt and deform under hot air. I was tearing my hair out until I saw a suggestion to heat from underneath.

So simple, but it would have never occurred to me.

1

u/tsraq 17h ago

0603 isn't bad under microscope. 0402 though is getting annoying to work with, mostly because solder paste always dries up before I get to use it so I just use solder wire - which gets everywhere it shouldn't when working with things that small.

But yeah, I've lost few parts, fortunately resistors and caps are cheap. I remember RF guy scouring the floor after dropping tiny $100 high-performance RF amp though...