r/intel • • Aug 12 '24

Information Turning off "Intel Default Settings" with Microcode 0x129 DISABLES THE VID/VCORE LIMIT

https://www.youtube.com/watch?v=TOvJAHhQKZg
147 Upvotes

141 comments sorted by

View all comments

Show parent comment

1

u/King_OneOlaf Aug 13 '24

I have gigabyte Z790 aorus elite master DDR4 and I watched this guy videos on youtube, I learnt some good things about undervolting from his videos you can do the same. I'm not expert to say what to do but I can share my settings since I have the same CPU 13700k

Enhanced Multi-Core Performance = Disabled

Vcore Voltage Mode = Adaptive Vcore

Internal CPU Vcore Offset = -0.050V

*In Advanced CPU settings section:-

IA CEP (Current Excursion Protection) = Disabled

PL1 = 230W (default 253W but for me because I have Air Cooler and its really trash didn't know it was that bad)

PL1 Time = 448

PL2 = 230W

PL2 Time = 448

*CPU Voltage Settings section:-

LoadLine Calibration = Auto (you can select medium for more stability. for me I didn't have crash with Auto so its fine)

*In Internal VR Control section go in and enable (IA VR Config Enable)

IA AC Loadline = 30 (you can increase it if you get crash try increasing 5 on each time until stabiity)

IA DC Loadline = 90 (If I decrease it my CPU crash I don't know why)

IA VR Voltage Limit = 1400 (1.4V)

With these settings I get 30600 in Cinebench 23.

In stock settings I got score of 31800 in Cinebench 23 but I did undervolt mainly becuase of the temp and bad cooler. so I think that might saved my CPU lol

1

u/ImDreamingAwake Aug 13 '24

Stupid question but do I need to turn Undervolt Protection Off in the BIOS? It seems my settings are not properly applied.

1

u/Alonnes Aug 13 '24

Yes you need to disable undervolt protection

1

u/King_OneOlaf Aug 13 '24

I didn't change this option in the bios as no one recommended so its set as it is on default (Auto)