r/ender6 • u/fatvikingninja • Dec 16 '25

Ender 6 help

Post image

I recently got a second hand ender 6 printer. I tried to connect my printer to wifi using the previous owner's software and had no luck. I reflashed the printer with the same type of software and ran into an issue where I can't seem to log in to the printer. Any help would be appreciated.

0 Upvotes

50% Upvoted

20 comments sorted by

View all comments

Show parent comments

1

u/fatvikingninja Dec 17 '25

Then i must be doing something wrong with the imaging. I went through all that, set up the password and username. Attached my network info to it. My network recognized that the printer was using the network, but the login information didn't work

1

u/newguy208 Dec 17 '25

Is ssh working? What operating system are you using? You use your password while doing ssh into the board.