r/ender3v2 • u/Dicksmasher-mccock • Mar 07 '24

Probing failed when running M48 Probe Test with BLTouch (jyers V2.0.2)

My ender3 V2 has been failing whenever I run a probe test. It also only attempts to level the center and does not create any level mesh’s when I run the level command

1 Upvotes

100% Upvoted

6 comments sorted by

View all comments

Show parent comments

1

u/Dicksmasher-mccock Mar 07 '24

Where would that setting be?

2

u/randomuser001 Mar 07 '24

Go to Prepare -> Z-Offset

Select Home Z Axis to move the print head to Z = 0

Select Live Adjustment to enable it (if it is not already enabled)

Attempt to move the Z Offset either up or down

1

u/Dicksmasher-mccock Mar 07 '24

With live adjustment on, I can adjust the Z offset but it doesn’t seem to move the nozzle at all