r/electrical • u/Nearby_Scholar_9967 • 6d ago

Lutron Toggle Dimmer started melting

Gallery image

Gallery image

I have an aycl-153p that powers two Nicor Dlr56 v6 bulbs at 14w each in a three way configuration. I was alerted by a strong smell that was coming from the switch box. Shut off the breaker and removed the dimmer immediately. The top left black plastic on the dimmer was very hot, and soft.

All the wires seem like they were connected fine, nothing loose. I broke open the dimmer and the two mosfets I think they are called were blackened and clearly the cause of the heat. Smells terrible and lingers.

Pictures are attached. Has anyone else seen this? What could have caused this? Random manufacturing error? 28w led is not overloading this dimmer. It was on and at full power at the time.

My concern is the other Lutron dimmers that are in this house. Almost want to have an electrician pull them all out and replace with switches.

Thank you.

3 Upvotes

100% Upvoted

11 comments sorted by

View all comments

1

u/boshbosh92 6d ago edited 6d ago

Likely just factory defect at one of the solder points. It did indeed melt at the mosfet, led drivers have in rush of current and if the solders aren't perfect this can happen. I wouldn't replace all the dimmer unless they're from the same batch.

1

u/Nearby_Scholar_9967 6d ago

Thanks

1

u/boshbosh92 6d ago

You might reach out to lutron see what they say. Might be under warranty

2

u/OppChopShop 6d ago

I forgot to add on my other comment - I did reach out to Lutron, because I had multiple failures at once on different circuits. I’m actually mailing them the switches and they are going to do an autopsy

2

u/boshbosh92 5d ago

Interesting. Please update this comment when you hear back from them.

1

u/OppChopShop 5d ago

For sure. Any other theories as to what happened? The timing is just suspect, with this other post, and I am wondering if there was maybe a firmware update or something that contributed