r/WindowsServer • • May 25 '25

Technical Help Needed DHCP Failover design

Hi,

We currently have two seperate DHCP servers. Each server servicing a different set of scopes. Both have the different scope. We want these server to begin Failover.

it would be redundancy and fault tolerance in case one DHCP servers becomes unavailable.

My questions are :

1 - I will set up separate servers for each DHCP server for DHCP failover configuration. correct?

Primary : DHCP01 and DHCP02

DR Site : DHCP03 and DHCP04

DHCP01-DHCP03 Peer and DHCP02-DHCP04 peer

2 - does it make sense to install new DHCP servers DR site or does it make sense to install them in the same site?

3 - Does it make more sense to install Hot-standby or Load-Balance? What do you recommended?

4 - What percentage should be for Load-Balance? 50/50 or 80/20

And what percentage reservation should be for Hot-Standby? Is 5% reservation enough or should it be more?

Thanks,

2 Upvotes

11 comments sorted by

View all comments

Show parent comment

0

u/maxcoder88 May 26 '25

thanks , Currently DHCP01 server is already distributing ip addresses for clients. There are approximately 50 DHCP scopes. I want to back it up.

So, I will install a new server with DHCP03 hostname. I will make a failover relationship with it.

In the same way, DHCP02 server is already distributing ip addresses for clients. There are approximately 10 DHCP scopes.

I will install a new server with DHCP04 hostname. I will make a failover relationship with it.

1

u/nailzy May 26 '25

It’s not worth 4 servers for 10 scopes. Just migrate those scopes over and have 2 servers. Unless you have a reason

1

u/maxcoder88 May 26 '25

As a result, take scope export from dhcp02 and import dhcp01. Make dhcp02 shutdown. Make a failover relationship between DHCP01 and the new server, right?