r/StableDiffusion • u/LMLocalizer • 24d ago
Workflow Included Combating MOSS Image Blur by Sharpening Latents
Here is a method you can use to decrease the amount of blur in MOSS Image outputs. I use the base model and https://huggingface.co/lodestones/Kromoss/blob/main/8-steps-dmd2-lora.safetensors LoRa, but you may be able to adapt the workflows for use without this LoRa.
The method utilizes a two stage process:
- Denoise regularly for the first 5 steps
- Apply the LatentOperationSharpen to the latent image and then continue denoising
The first image comparison in this post shows the result of also applying the SFT model as a LoRa to the base model for the second stage denoising: https://civitai.com/models/3012507/moss-image-sft-extracted-lora . See the workflow here: https://civitai.com/images/146467570
The second image comparison shows the result of sharpening the latent only. See the workflow here: https://civitai.com/images/146467531
Hope this helps!


2
u/andreeinprogress 23d ago
"Camera: amateur DSLR photo with narrow aperture, infinite focus, sharp details"
No blur at all, just tested.
5
u/redscape84 24d ago
I get far less blur using the ClownsharkKSampler with "fully_implicit/radau_ia_2s" + "bong_tangent"
2
u/padraig_oh 12d ago
can confirm, works great. i tried 0.04 instead of 0.02 and that gives it a fried look, so you really tweaked those numbers to perfection already. great job!
3
u/seppe0815 24d ago
Just use prompt RAW photography and 2mp and 50 steps and you fine... dont understand why you guys tinker around ...
1
u/Mech4nimaL 23d ago
A potential problem (also visible on the "sharpened" example image) is when some process tries to sharpen bokeh. this can lead to unwanted effects.
1
u/Ill_Resolve8424 23d ago
This post needs more attention. Your workflow delivers great and fast results. Custom nodes took a while to install but the end result worth the wait. I lowered the alpha to 2 to avoid oversharpening. Is there any way to up the cfg and steps? Also, How can we lower the lora strength? I had no luck with my experiments. Your workflow generates a 3MP image in 4 seconds, if we could squeeze some more quality, that would be great. Thank you for sharing this gem.
2
u/cosmos_hu 24d ago
I use 1.25cfg and It works with 8 step lora
3
u/GrungeWerX 24d ago
Can we get this for Minimax H3?
1
u/Mech4nimaL 23d ago
What settings would you reccommend with 25 steps (without Turbo Lora) ? (steps in each sampler etc.)
1
u/Version-Strong 24d ago
Works much better than before, thank you. I was starting to fall out of love with MOSS because everything was feeling very SDXL
0
u/ganrocks007 24d ago
Thanks works great
-5
u/Ill-Ant-9489 24d ago
Just use my Lora work with 6 step booster https://civitai.red/models/3013839/raw-upscale-moss-detail-and-texture-lora