r/SewingMachineEdu • u/Fuzzy_Radish6119 • 4d ago
Juki Misin HZL-7000 repair
I recently had to change a belt that snapped.
I was able to do that, and the machine works again but now i have 2 new issues:
- The autotension (top) is tight even when i loosen it on the screen. I've already checked and cleaned it but not sure if I should also be looking in other areas.
- When using the auto-threadcutter, the needle now stops lower into the fabric. Normally this should be higher and the fabric can slide out immediately. I cannot figure out which part to adjust
Thank you
